MOVIMOT can be equipped with a BEM, BES or URM brake control system as an option in conjunction with a modular terminal box. The option is integrated in the MOVIMOT terminal box. BEM controls the standard brake, BES controls the DC 24 V brake. URM is a voltage relay for controlling brakes.
The BW100***/BW200*** braking resistors in IP65 enclosure convert the MOVIMOT drive's regenerative energy of up to 100 W/200 W (0.134 hp / 0.268 hp) continuous power into heat.
The BW150**/BW068** braking resistors in IP66 enclosure convert the MOVIMOT drive's regenerative energy of up to 600 W/1200 W (0.805 hp /1.609 hp) continuous power into heat.
The optional DC 24 V power supply MLU11A is mounted in one of the MOVIMOT cable entry openings and allows for operation of one MOVIMOT® including an option with a current consumption of up to 70 mA (MBG11A, MWA21A) without an external 24 V auxiliary power supply.
The optional integrated DC 24 V power supply MLU13A is mounted in the MOVIMOT terminal box and allows for operation of one MOVIMOT® including an option with a current consumption of up to 70 mA (MBG11A, MWA21A) without an external 24V auxiliary power supply.
The optional MLG**A setpoint generator is mounted in one of the cable entry openings of MOVIMOT and offers the possibility of adjusting the input speed in the range of -100% to +100 % fmax (potentiometer f1) as well as of powering the inverter with the DC 24 V auxiliary voltage.
The optional MBG11A setpoint control module has two keys and a display. MBG11A** makes it possible to adjust the speed remotely in the range from -100% to +100% fmax (potentiometer f1). Up to 31 MOVIMOT units can be controlled at the same time.
The optional MWA21A setpoint converter converts an analog setpoint and the control signals into an RS-485 protocol. The MWA21A enables the MOVIMOT to be controlled remotely from the control cabinet. Up to 31 MOVIMOT units can be controlled at the same time.
The DBG60B keypad can be used to control MOVIMOT drives with integrated AS interface in manual mode. Furthermore, important information can be displayed in monitor mode.
The DBG60B keypad is connected to the diagnostic interface in the MOVIMOT terminal box.
The optional MDG11A diagnostic unit indicates the operating status, output current, terminal status and MOVIMOT® fault codes when faults occur.
The MNF11A integrated line filter option is mounted in the MOVIMOT terminal box and allows for a drive system that complies with the emitted interference stipulated in EN 61800-3 as well as with the class B limit according to EN 55011 and EN 55014.
The P2.A mounting plate option allows the MOVIMOT inverter to be mounted away from the motor (offset). The inverter is connected to the motor using a pre-fabricated hybrid cable. MOVIMOT with option P2.A is supplied in enclosure IP65.